delete- i got'em

i need a set of tranny stiffners (or whatever there called) for my 20r. they are the same as a 22r.

let me know if ya got some

Not quite sure what your talking about. Tranny Mounts? cause if thats the case http://www.4xinnovations.com/ these are hardcore. I have one OE mount and one of these.

nah, the brackets that go from the engine block to the lower bolt holes on the bellhousing.

what crossmember you running? you got the stock transferscase mount in front or back?

bump

Have you tried Dave's yet??? http://www.davezoffroadperformance.com/

nope... didnt even think of davez

thanks

no-idea wrote:nah, the brackets that go from the engine block to the lower bolt holes on the bellhousing.

what crossmember you running? you got the stock transferscase mount in front or back?

I am running the stock one in the front and the 4x inovations one in the back I figured this way I would get the dampning effect of the stock rubber one and the hardcore one in the rear would keep the front one from ripping again. I went through two with my single case so when I went duals I decided to beef it up just a little.

so no luck with davez :(

Jay D wrote:

no-idea wrote:nah, the brackets that go from the engine block to the lower bolt holes on the bellhousing.

what crossmember you running? you got the stock transferscase mount in front or back?

I am running the stock one in the front and the 4x inovations one in the back I figured this way I would get the dampning effect of the stock rubber one and the hardcore one in the rear would keep the front one from ripping again. I went through two with my single case so when I went duals I decided to beef it up just a little.

hmm i have 2 stock mounts... maybe i should order that one from adam. hows the vibs? any worse then before?

Try toyautomart in Rancho Cordova


Toyautomart
3410 Sunrise Blvd
Rancho Cordova, CA 95742

(916) 635-8900

no-idea wrote:so no luck with davez :(

Jay D wrote:

no-idea wrote:nah, the brackets that go from the engine block to the lower bolt holes on the bellhousing.

what crossmember you running? you got the stock transferscase mount in front or back?

I am running the stock one in the front and the 4x inovations one in the back I figured this way I would get the dampning effect of the stock rubber one and the hardcore one in the rear would keep the front one from ripping again. I went through two with my single case so when I went duals I decided to beef it up just a little.

hmm i have 2 stock mounts... maybe i should order that one from adam. hows the vibs? any worse then before?

To tell you the truth My truck was down for so long before I got it up and running agian that when I put that mount in I didnt notice anything. I dont DD it so vibrations dont bug me.

just talked to dave himself, he said 20 shipped!

thanks for the help guys