tranny swap

clutch slave cylinder mount done
clutch fork adjuster done

well chris and i went to pnp for a new bellhousing and flywheel because
the starter hit the bellhousing and the flywheel was to small!!!!!damit
so used bellhousing at pnp $30

used flywheel $27
new clutch kit from az $120
and i still need a new front 30 spline yolk for a 1350 joint $100 from dls
but the tranny is in and working
going to finish the clutch setup today(whole new braket for slave)
and try to mock up the brake master and pedal tonight

well now i get to swap front outputs because no one makes a 30 spline 1350
205 yolk
so im puting the orignal 10 spline 1350 yolk output in the new case so i can still run my offset u-joints so it wont bind when flexed
yea fun all over again

output's are swapped !easier than i thought it would be!
clutch pedal and master are done!
reworked my bracket for the clutch slave done!
brake pedal and master are done! it will work for now
test drove it
brakes work better
no noises from t case or tranny
and it idles up my driveway woo hooo
ill put the guages back in tomorrow

Nice!!!!