81 Toyota

Got my marlin mc07 and my topshift case. Also have a drop bar for front to fix pinion angle on front axle. I will post updates and pics as I go. Still need a front drive shaft to build a square out of.

I might need to access a press in a week or so if any one has one in the sacramento area. I may just buy one but wanted to see if any one had one.

what do you need a press for?

Reading the instructions for the MC07 it shows using a press to get the gear of the mainshaft is there another way?

Jay D wrote:Reading the instructions for the MC07 it shows using a press to get the gear of the mainshaft is there another way?

Well the Swing press isnt what they said to use but it sure worked fine. Here is my Case almost ready to go on. Now all I need to do is weld in the front drop bar to fix my horible pinion angle on my front axle, Build some drivelines and order my bud built cross member. I cant wait to try it all out.

Are you sure you need to install the hanger to help with the pinion angle? When you install the dual case the angle won't be as steep due to the t-case is moved back. I would install the dual case first & see how it looks.

I dont have too but I would prefer to I know it will make it allot better with the dual cases but I already bought the hanger and I would prefer as little driveline angle as I can get but I do appriciate the advice.

Ready to bolt up but I need a C clip for one of the shifters I tried to source one at the hardware store but its not the right style and it dosnt quite fit any one know where to get one that will fit that I can source locally?

Update:
Shifter C clips sourced from Toyota dealer Dual cases in the truck. No drivelines on it yet I will be sorting that out after christmas I also am waiting to figure out a crossmember I am pretty sure I am going to go with the bud built crossmember I really like the single case version I had. I also plan to pull the third in the rear and put the stud eliminator kit from trail gear in it needs to be resealed and one of the studs is strippedin the rear any way.

As far as a shift boot for the second shifter. Pick in pull 81 Toyota Celica Manual transmission shift boot works perfectly.

HELLL YEAH MAN GET IT

I JUST ORDERED MY FRONT AUSSIE LOCKER!!!

Sweet! How do you have to wait? I heard they are back ordered a few weeks.

when did you do that I sit right next to you

BIG BLING wrote:when did you do that I sit right next to you

I hope your not the boss

Tallchevy350 wrote:Sweet! How do you have to wait? I heard they are back ordered a few weeks.

I contacted the compay last friday and they got back to me yesterday and said that they are getting a shipment at the end of this week and that some are presold and they told me to get my order in asap. So hopefully it will ship next week.

BIG BLING wrote:when did you do that I sit right next to you

Sneaky Sneaky